A plasma cutting machine is not only very useful for cutting metal, but it also comes with several pitfalls that need to be avoided to ensure that you get the best cut possible. Using the wrong consumables can lead to shortened parts life and poor cut quality. Additionally, it is important to run the machine at the correct amperage, which should be around 95 percent of the nozzle’s rating. There are a few tips that will help you get the most out of your plasma cutting machine. Click this to know the price of a plasma cutting machine.
Replace worn consumables:
There are several reasons why you should replace worn consumables, and it’s important to do it often. Most shops will change them after a certain number of pieces or during a shift change. The most important one to replace is the electrode since bad electrodes can result in a faster breakdown of the torch. Luckily, there are a few easy ways to make sure that your plasma cutting machine is getting the most life possible.
Make sure your air system is properly sized and installed:
Next, make sure your air system is properly sized and installed. If it isn’t, it will affect the performance of the plasma cutter. Secondly, make sure you’re using the correct power source. This is because a lower power source will result in a lower output. Always make sure you use a proper extension cord or generator to connect your plasma cutting machine to the wall.
Prevent water from getting into the plasma stream:
If you want to get the most from your plasma cutting machine, you must ensure that the air that the torch uses is as clean as possible. Water and oil in the air supply will affect the quality of the cut and may even cause rapid wear on cutting consumables, including the electrode and nozzle. To keep these items in top condition, you must prevent water from entering the plasma stream.
Adjusting the angle of the torch to get a square edge:
Getting a square edge on your cut is essential for good quality work. Plasma cutting machines come with a specific plug and panel mount for the torch. The angle of the torch should be set between 8 and 15 degrees to ensure that the cut is square. The angle can be adjusted to the right or left to achieve the best results. Depending on the type of material you are cutting, you can use different torch attachments to get a square edge.